Pinion shaft chewed up
Thread Starter
Junior Member
Joined: Jul 2005
Posts: 6
Likes: 0
From: Cedar Park, Texas
Car: '72 Elky, '85 TA, '87 GTA, '93 Chevy PU, '94 Z28
Pinion shaft chewed up
87 GTA, aussie 9 bolt rear-end. Pinion shaft bearing broke and car was driven with the shaft just bouncing around in the diff housing. Shaft is too chewed up now to take a new bearing.
Am having problems finding a replacement shaft. No one, but no one seems to have it. Junk yards will only sell me a used 10-bolt, but I don't want to lose that aussie rearend. All original from the factory.
Any suggestions?
Am having problems finding a replacement shaft. No one, but no one seems to have it. Junk yards will only sell me a used 10-bolt, but I don't want to lose that aussie rearend. All original from the factory.
Any suggestions?
Re: Pinion shaft chewed up
You will need a new Dr Pinion and the only way you can get one is a new 9-bolt Gear Set.
Reason: dr pinion and dr gears are matched sets and Only sold as sets.
Reason: dr pinion and dr gears are matched sets and Only sold as sets. Thread Starter
Junior Member
Joined: Jul 2005
Posts: 6
Likes: 0
From: Cedar Park, Texas
Car: '72 Elky, '85 TA, '87 GTA, '93 Chevy PU, '94 Z28
Re: Pinion shaft chewed up
And there in lies my problem. Am having problems locating a 9-bolt gear set for the aussie differential.
Any suggestions?
Any suggestions?
Joined: Aug 2006
Posts: 12,813
Likes: 110
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: Pinion shaft chewed up
what ratio? have you look ed at ebay yet?
http://cgi.ebay.com/ebaymotors/Camar...spagenameZWD1V
http://cgi.ebay.com/ebaymotors/Camar...spagenameZWD1V
http://cgi.ebay.com/ebaymotors/Camar...spagenameZWD1V
http://cgi.ebay.com/ebaymotors/Camar...spagenameZWD1V
Thread
Thread Starter
Forum
Replies
Last Post
[CA] 700R4 trans & parts
6998poncho
Engine/Drivetrain/Suspension Parts for Sale
0
Sep 25, 2015 02:56 PM
dimented24x7
Transmissions and Drivetrain
7
Sep 17, 2015 06:58 AM






