I'm in the market for a new drive shaft. Where can I get an inexpensive new or used one for a good deal?

 

Check in the classifed section of this board.I see them in there all the time from $50-$100.

 

If you're looking for a new one: http://www.worldparts.com/vandevereoldsmobile/
ask for Dal.

 

I have one for sale in the classifieds, 88 Camaro, slip yoke, decent shaft, rear caps are missing. I've sold alum shafts to many people on thirdgen. $155 shipped, money order, certified check or PayPal.

JamesC

------------------

 

I picked mine up from the junk yard out of a 89 IROC for $15-20 and then had new u-joints installed before I put it in the car. Check around the junk yards and make sure they are not dented or dinged up because thee dents will cause it to not be balanced properly when its rotating.

------------------
1988 TA 300+hp 350 w/ TBI and Holley TB unit, Holley projection intake,
WC T-5, 3.42 gears w/ Auburn posi. MSD 6A, edelbrock TES headers, dynomax 3" cat and cat-back system, ACCEL coil, polyurethane bushings all around, aluminum driveshaft, Mr. Gasket open air cleaner.

1993 S-10 w/ 4.3L V6 TBI, slightly bigger cam, Mild polish job and 3 angle valve job on heads, Edlebrock TES headers, Dynomax cat back, MSD 6A, ADS chip

2000 Kawasaki KX 125