NEED HELP ASAP! Aluminum DS and U-Joint questions
Thread Starter
Member
Joined: Aug 1999
Posts: 177
Likes: 0
From: Columbus, GA USA
NEED HELP ASAP! Aluminum DS and U-Joint questions
I have a 92RS and I am trying to put an Aluminum shaft in but the u-joint at the rear won't tighten in the rear end retainers. Does anybody know what could be the problem? 
Supreme Member
Joined: Jul 1999
Posts: 2,767
Likes: 2
From: Vereinigten Staaten
Car: Take
Engine: Your
Transmission: Pick
Make sure the u-joint is perfectly centered in the Companion Flange (yoke) if the differential.
------------------
If you live in Southeastern US, check us out!
South East Thirdgen
"I used to have a handle on life, but then I used it as a plunger and broke it" -The Wave
ASE Master Tech + L1
Savannah, GA
'87 Trans Am-K&N,Cold air induction, SSM SFC, Boxed LCAs, 8mm Accel wires, Flowmaster, 16" GTA rims.
'97 Bonneville SSE
------------------
If you live in Southeastern US, check us out!
South East Thirdgen
"I used to have a handle on life, but then I used it as a plunger and broke it" -The Wave
ASE Master Tech + L1
Savannah, GA
'87 Trans Am-K&N,Cold air induction, SSM SFC, Boxed LCAs, 8mm Accel wires, Flowmaster, 16" GTA rims.
'97 Bonneville SSE
Senior Member
Joined: May 2000
Posts: 637
Likes: 36
From: Central NJ
what do you mean they wont tighten?? check to make sure the bolt holes arent stripped...if they are, go beat the guy w/ his driveshaft 
------------------
350, Comp 262, Edelbrock Performer intake 600 cfm carb and exhaust, headers
------------------
350, Comp 262, Edelbrock Performer intake 600 cfm carb and exhaust, headers
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM
91 rally sport
Engine/Drivetrain/Suspension Parts for Sale
22
Apr 5, 2016 05:06 PM