Hi everyone, I am in the process of swapping my 700R4 out of my IROC for a T-5. I will be cutting the hole in the floor this week for the shifter access and was wondering what others have used to do this on their cars - (wizzer wheel, saws-all, hacksaw, etc) any tips or tricks would be greatly appreciated - thanks - Erik

86 IROC-Z
Silver/Dk Carmine red deluxe int.
305 TPI soon to be T-5
2000 NE Dragway all Camaro show - Best of Show runner up
2000 Heberts cruise night feature car
2000 Shrewsbury Fall Brawl car show 2nd place

 

at work we have a 110 volt plasma cutter.it worke really nice on sheetmetal and makes a nice cut.
mike

 

I used a sawzall on mine

------------------
Proud owner of the slowest L98 in the North East
1987 IROC 5.7 - 16.43 @ 82 the project
1986 S10 4x4 w/93 Vortec 4.3 - the nitemare
1988 Formula WS6 - the Cow

 

I used a sawzall until i broke all the blades, then i used a jigsaw to finsh it up.

 

I used a cutter hooked to an air compressor. Other than waiting for the compressor to keep up, it worked fine.

------------------
Mark Lock
- 86 IROC-Z - SuperRammed 383/T56
- -= IROC Online =- - The site dedicated to the IROC-Z

 

I used a Dremel tool with a cutoff wheel.