I have headman shorty headers with a t56 and a spohn crossmember. I love the crossmember its tough and a good simple design, but Im afraid I wont be able to use it because I dont know how to get my pipes around the crossmember without hanging too low> The old pipe went between the oil pan over to the pass> side connected with driver side and went around to the cat. Im not using a cat So I would like to go strait down both sides of the transmission and then into my 3 inch hooker Intermediate Pipe. Has anybody done this? I might end up having to make My own crossmember with 2 places for the Pipe to go through. The thing that sucks is I just bought my crossmember less than a week ago. If anybody wants it Ill save them some money.