i recently installed a new cutch/pressure plate and i resurfaced the fly wheel on my chevy p/u. Its a 5 speed manual, i also replaced the pilot bushing and the t/o bearing. Now my problem is, is that it's going into gear but its not catching, my clutch release cylinder is operating. whenever i re adjust it, i get pressure to the clutch pedal but it gets harder everytime i push it down and it will eventually lock up. Someone please help, its a 91 chevy p/u/350/5 speed, thanks

86 Iroc tpi,305
91 chev p/u/350/3.73 gears/ram-air

 

Can someone pleasehelp me, im desperate here

 

I had the same thing happen on my firebird and i couldnt figure out what it was...took it to a shop and they installed a new clutch and no problems...i dunno what i did wrong!

------------------


" I'd rather run last in a full out race, than to NOT run at all ".

 

Graeme'sFirebird,
Hey when you took your car in about how much ddi it cost... did that include the new clutch assembly? and the lfly wheel resurfaced, or?
thanks