1. what exactly does this firm up, the 2-3 shift?
2. the vette servo firms the 1-2, right?
3. where is the boost valve located and how hard is it to install??
THANKS
------------------
1988 GTA Trans Am 350tpi: 46k miles,3:27 BW rear, aftermarket t-tops
Hotchkis: subframe connectors & strut tower brace
Flowmaster: 3inch exhaust& dual chamber muffler
Accel: 8.8mm wires, cap&rotor, u-groove spark plugs
Edelbrock: 52mmTB, intake & runners
K&N: filtercharger
TPIS: 170* stat, afpr, mat relocation kit
March: performance crank and alternator pulleys
Hypertech: 176* fan switch
Other mods: ported plenum, gutted cat, tb coolant bypass, homemade cold air induction, flux capacitor, driver side floor mat removed
2. the vette servo firms the 1-2, right?
3. where is the boost valve located and how hard is it to install??
THANKS
------------------
1988 GTA Trans Am 350tpi: 46k miles,3:27 BW rear, aftermarket t-tops
Hotchkis: subframe connectors & strut tower brace
Flowmaster: 3inch exhaust& dual chamber muffler
Accel: 8.8mm wires, cap&rotor, u-groove spark plugs
Edelbrock: 52mmTB, intake & runners
K&N: filtercharger
TPIS: 170* stat, afpr, mat relocation kit
March: performance crank and alternator pulleys
Hypertech: 176* fan switch
Other mods: ported plenum, gutted cat, tb coolant bypass, homemade cold air induction, flux capacitor, driver side floor mat removed
Supreme Member
Increases pressure on all shifts(pretty sure). Located right next to the pick-up tube for the tranny filter. One snap-ring and it falls out.
------------------
82 camaro--original steering wheel, brake/gas pedals, seats--everything else modified
82camaro
------------------
82 camaro--original steering wheel, brake/gas pedals, seats--everything else modified
82camaro