Hey guys. I purchased a crossmember for my T56 a while back from Skulte and now I see they've come up with a new design that allows you to run the exhaust right through where the crossmember mounts. My dillema is this. I've been layed off for awhile now and money is extremely tight. I have alot of extra steel and a welder in my garage / shop at my house. I was looking to see if any of you guys made your own crossmember. Just looking for ideas really to get me started. My custom y-pipe to my custom 4" over axle exhaust sounds really nice by is quite low under the crossmember.

Any help would be appreciated.

Thanks.