Hello I just installed a b&m transpak in my 700r4, after installation it wouldn't move while in gear. I figured i didn't put enough fluid so I added another 5 quarts and now it'll only move in the forward gears and very slowly, I have to rev it to get it moving even a little. I did this myself and it was my first time doing this, I followed the instructions to a tee and spent hours doing it, I realize there is a chance I installed some part wrong so tomorrow I am going to redo the whole thing. The only thing I had a hard time with was the pressure control valve as I did this with the trans in the car. Any advice on why my trans is doing this would help me a lot and give me something to watch out for. Please don't tell me to throw it away or buy a different kit, I don't need that kinda thing right now, just help with what I have would be appreciated thanks!