correct install of the throw out bearing T5
Thread Starter
Junior Member
iTrader: (2)
Joined: Aug 2008
Posts: 39
Likes: 2
From: wausau WI
Car: 1992 25th Anni. camaro
Engine: 5.7 liter ZZ4 swap TPI
Transmission: T56 (manual 6 speed)
Axle/Gears: corp. disc GM 10 bolt, 3:42
correct install of the throw out bearing T5
The throw out bearing is not compleatly round. The area that makes contact with the fork. Which direction should the tapper face? Into the fork or 180 degree's away?
Joined: Jul 2000
Posts: 6,522
Likes: 92
From: Aridzona
Car: `86 SS / `87 SS
Engine: L69 w/ TPI on top / 305 4bbl
Transmission: `95 T56 \ `88 200-4R
Re: correct install of the throw out bearing T5
If the taper sticks out, face it away from the fork.
If it doesn't it doesn't matter.
If it doesn't it doesn't matter.
Thread Starter
Junior Member
iTrader: (2)
Joined: Aug 2008
Posts: 39
Likes: 2
From: wausau WI
Car: 1992 25th Anni. camaro
Engine: 5.7 liter ZZ4 swap TPI
Transmission: T56 (manual 6 speed)
Axle/Gears: corp. disc GM 10 bolt, 3:42
Thread
Thread Starter
Forum
Replies
Last Post
red90IROCls1
Transmissions and Drivetrain
10
Aug 25, 2015 06:56 AM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM
rsrmoore
Transmissions and Drivetrain
1
Aug 7, 2015 08:44 PM
