shifting into 3rd after rebuild
Thread Starter
Junior Member
Joined: Sep 2006
Posts: 32
Likes: 0
shifting into 3rd after rebuild
had transmission rebuilt by a professional.grinds going into third,it does it for a period of time,then goes away,but comes back again. its been back twice,and they have no idea why.any suggestions?at a total loss!!
Joined: Sep 2005
Posts: 27,893
Likes: 2,436
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: shifting into 3rd after rebuild
If this is a manual transmission, .... ,,, ...
Change the pilot bearing / bushing.
Change the pilot bearing / bushing.
Joined: Sep 2005
Posts: 27,893
Likes: 2,436
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: shifting into 3rd after rebuild
Personally I prefer the bearing, but there's nothing at all wrong with the bushing. In fact some people prefer it, not least because it's easier to get back out when you have to replace it.
Thread
Thread Starter
Forum
Replies
Last Post
TheTraut88
Engine/Drivetrain/Suspension Parts for Sale
1
Sep 7, 2015 05:22 PM