B&M MEGA SHIFTER TRANSMISSION. BRACKET SPACERS.
Thread Starter
Joined: Jan 2009
Posts: 539
Likes: 0
From: Texas
Car: 1991 Trans Am GTA
Engine: 350 tpi
Transmission: 700R4
Axle/Gears: 3.42
B&M MEGA SHIFTER TRANSMISSION. BRACKET SPACERS.
What's up guys...does anybody know where I can find the spacers used to install the b&m megashifter tranny bracket to the tramsmission? Cam I find them at a hardware store?
Supreme Member
iTrader: (13)
Joined: Dec 2002
Posts: 2,535
Likes: 17
From: Bowdon, GA.
Car: 1988 Camaro
Engine: 355, 10.34:1, 249/252 @.050", IK200
Transmission: TH-400, 3500 stall 9.5" converter
Axle/Gears: Ford 9", detroit locker, 3.89 gears
Re: B&M MEGA SHIFTER TRANSMISSION. BRACKET SPACERS.
I have used just 3/8" or 7/16" nuts before if you are talking about the shift cable to trans pan bracket. Buy at hardware store.
Thread Starter
Joined: Jan 2009
Posts: 539
Likes: 0
From: Texas
Car: 1991 Trans Am GTA
Engine: 350 tpi
Transmission: 700R4
Axle/Gears: 3.42
Re: B&M MEGA SHIFTER TRANSMISSION. BRACKET SPACERS.
Yes the spacers they provide to put between the bracket and transmission. So a 3/8 nut will do or 7/16
Supreme Member
iTrader: (13)
Joined: Dec 2002
Posts: 2,535
Likes: 17
From: Bowdon, GA.
Car: 1988 Camaro
Engine: 355, 10.34:1, 249/252 @.050", IK200
Transmission: TH-400, 3500 stall 9.5" converter
Axle/Gears: Ford 9", detroit locker, 3.89 gears
Re: B&M MEGA SHIFTER TRANSMISSION. BRACKET SPACERS.
Yes sir. The common std. 3/8" nut is a little thin, 7/16" is just right. I have found some 3/8" nuts that was thicker than the std. ones and they worked too.
Thread Starter
Joined: Jan 2009
Posts: 539
Likes: 0
From: Texas
Car: 1991 Trans Am GTA
Engine: 350 tpi
Transmission: 700R4
Axle/Gears: 3.42
Re: B&M MEGA SHIFTER TRANSMISSION. BRACKET SPACERS.
Ok I'll go out and get 2 7/16th nuts and try it out...u would not happen to k ow the bolt I need? I know I need longer ones I believe a m8?
Thread
Thread Starter
Forum
Replies
Last Post