Yes folks, I have been scouruing the web for 3 weeks now, and I have finally amounted a nice group of pages that I will be using to contruct new benders, milling machines, ect.

Yes a mandrel bender(under hydraulic power even) for roughly $300.
Milling machine, well thats still up int the air, as far as price goes, but yes it is on the "to-do" list.
I have even been thinking about small plates to be bolted to the head that will adapt the small, 1 1/8" ports, to a much larger 1.5" OD, or roughly larger then 1 3/8" ID, effectivly increasing porting ability a full 1/4".
I have also been tooling numberous intake ideas, including a FULL TPI style bolt on. Along with a 70MM eliptical butterfyl, being 70MM tall, and 80-85 accross. Effectivly creating a 90MM(1/3 larger!) or so opening.

 

Still need an answer on the ADL cable

 

I did answer int eh old thread. I can put it togeather minus the chip, as my freind does not have one for about $20. You can call and ask Maxim to send you samples of the chips, and they will send 3-5 for free.