Cruise Control
Thread Starter
Junior Member
iTrader: (1)
Joined: Aug 2008
Posts: 39
Likes: 0
Car: 1985 Camaro
Engine: 2.8l v6
Transmission: auto
Cruise Control
I know this may have been posted before, I have searched but didn't find anything. I have a bone stock 1985 sport coupe camaro with the 2.8l, I want to add factory cruise control, is there any difference in the v6 than the v8, if so what parts do I need?
Supreme Member
iTrader: (8)
Joined: Aug 2003
Posts: 7,240
Likes: 6
From: LeRoy, NY
Car: 2003 Hyundai Tiburon GT
Engine: 2.7L V6
Transmission: 6-speed
Axle/Gears: 4.41
Re: Cruise Control
Not really any difference AFAIK, except maybe the length of the cable coming off of the modulator.
You need the ENTIRE underdash harness, the brake cutout switches (pedal bracket mounted), the module inside the dash, vacuum hoses, the modulator in the engine bay, and possibly a bracket to hold the end of the cable on the TB if yours doesn't have a spare hole where the cable would be if installed, along with a clip to hold the cable end on the throttle lever.
You need the ENTIRE underdash harness, the brake cutout switches (pedal bracket mounted), the module inside the dash, vacuum hoses, the modulator in the engine bay, and possibly a bracket to hold the end of the cable on the TB if yours doesn't have a spare hole where the cable would be if installed, along with a clip to hold the cable end on the throttle lever.
Thread
Thread Starter
Forum
Replies
Last Post
wigmobile
Electronics
5
Feb 26, 2025 02:56 PM