V6 Discussion and questions about the base carbureted or MPFI V6's and the rare SFI Turbo V6.

engine not cooling

Old Jun 22, 2001 | 01:36 AM
  #1  
dyslexicgod's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2001
Posts: 2
Likes: 0
From: SF Bay Area CA
engine not cooling

OK.. I gotta '91 bird with a V6. I was leaking coolant and overheating, so.... I replaced the H20 pump. When that didnt work I knew the leak was my freeze plugs. After pulling the engine replacing 3 blown plugs, I finally got the engine back in place. well.. then I found a leak in the radiator. To boil it down I replaced the radiator, the cap, the upper and lower radiator hoses, but the engine is not cooling. When I start the engine and let it idle to up to temp <with the heater on> the engine never cools. I am about to replace the thermostat.. but is there anything else I may be overlooking.. I have followed my repair manuals. I am at a loss..... Any help or advice out there??? thx
Reply
Old Jun 22, 2001 | 08:56 AM
  #2  
KED85's Avatar
Supreme Member
 
Joined: Jan 2001
Posts: 7,604
Likes: 1
From: ****SoCal, USA****
Does operating the heater (ON HEAT, FAN BLOWING), while it's hot, lower temp?
Does the fan turn on?

------------------
Chat Soon,
KED85
Karl
1985 Firebird 2.8 to 3.4 swap project for Smog Happy LA, CA
Reply
Old Jun 22, 2001 | 11:18 AM
  #3  
Kevin S's Avatar
Member
 
Joined: Jan 2000
Posts: 384
Likes: 0
From: Pt. Pleasant, WV (Home of the Mothman!)
It sounds like you have covered everything.
Like KED85 mentioned,does you fan come on?Normaly the fan won't come on until the temp gets close to 220.Atleast that is where mine kicks on.I also have mine connected to a switch so I can turn it on when I want to.
If it works then it looks like the thermo is the last thing.If that doesn't work then it could be something internal.We'll hope not!

------------------
Kevin S
89 RS w/2.9
modded some but not heavily



"I am just as enthusiastic about flying saucers as I always
was, but the problem is that we are in the middle of a
long, long trough. There's only so many times you can pick
over old bones. There just aren't enough new sightings. It
is not like being a philatelist - there is always something
new to say about stamps."

- Denis Plunkett, 70, a retired civil servant from Bristol
who founded the British Flying Saucer Bureau, which has
suspended its activities because of an apparent sharp
decline in the number of alien visitors to Earth.
Reply
Old Jun 22, 2001 | 04:10 PM
  #4  
dyslexicgod's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2001
Posts: 2
Likes: 0
From: SF Bay Area CA
the fan finally kicked on last night at about 230 degrees.... the good news is it didnt shoot str8 to the red.. the bad news is it is holding at 230... but I have been to lazy to go do the thermo yet today <OK actually it is way too hot outside to go change it> but I have my fingers crossed.. thanx
Reply
Old Jun 22, 2001 | 04:45 PM
  #5  
Horst's Avatar
Member
 
Joined: Jun 2000
Posts: 216
Likes: 0
From: Schotten, Germany
Car: Firebird
Engine: 3.1 L
Transmission: auto
you could have air in the system and the coolant can't circulate?

------------------
www.marion-becker-nidda.de
91 Firebird 3.1
Modsynomax ultra flow stainless steel -americanracing rims (ar26) rear 15x8 255/60
front 15x7 235/60
www.members.aol.com/tramphorst/pontiacpics
Reply
Old Jun 22, 2001 | 07:16 PM
  #6  
KED85's Avatar
Supreme Member
 
Joined: Jan 2001
Posts: 7,604
Likes: 1
From: ****SoCal, USA****
TRY TURNING ON THE HEATER (blower & temp on HIGH) NEXT TIME IT GETS HOT.
Tell us what happens.

I strongly think you have bad air flow to the radiator.
Like lower deflector is missing.
One of those things missing really heats up this car, BAD.
Did you blow compressed air out of the A/C condensor, to remove any debris?

------------------
Chat Soon,
KED85
Karl
1985 Firebird 2.8 to 3.4 swap project for Smog Happy LA, CA
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Streetstuff
Carburetors
13
Sep 7, 2015 02:33 PM
TheExaminer
Cooling
26
Aug 26, 2015 04:59 PM
Bryan F
Tech / General Engine
2
Aug 18, 2015 02:28 PM
sreZ28
Engine Swap
4
Aug 14, 2015 07:48 PM
bradleydeanuhl
DFI and ECM
4
Aug 12, 2015 11:48 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 08:08 AM.