Does anyone know where the HECK to get a manual flywheel for a 2.8 liter pontiac? Can has T5. I've called everywhere. And if autozone can't get it for me, I don't know who can. Junk yard? Thanks, also how hard would it be to install?

------------------
1984 Firebird SE
1985 Camaro z28 305 engine T-5 Five Speed Tranny, 92 Camaro Leather Seats Console, carpet everything. Soon to put in 700R4 and 427CI. (Hopefully.
To view my car go to:

http://geocities.com/jmboriss/bluecar.html

It is also for sale, please make me an offer. Thanks.

 

I pulled one out of the local pick-a-part. I think it cost me around $15. It needs to be resurfaced though. About $30. You gotta pull the tranny to install it so access to a lift would really help.

Did you try your local dealer?

EDIT: Oh yeah, thanks for stretching out the screen.
------------------
-Dan
-1990 3.1L RS
-Mods? no
-Slow? yes
-*Slowly* collecting parts for T5 swap


[This message has been edited by CaliCamaroRS (edited November 03, 2001).]

 

Autozone has a flywheel for my car, how do i know, I work there.

------------------
Chevy 2.8L 60° V6
Mods:
?K&N Filter Lid
?87 Formula Hood
?Bosch Platinum +4
?Hi-Flo CatCo CAT
?Flowmaster 80 Series Muffler
?83 Trans Am 15x7 Turbo Fin Wheels
?B.F.Goodrich Radial T/A 225/60-15
?Chevy 2.8L Heddman Headers (Going on soon)

Aol instant messenger: FIREAM

<A HREF="http://digilander.iol.it/simpson50/1_multimedia/simpson/gif_animate/06/homer_14.gif

http://www.geocities.com/fiream/RobsCarArtPa.html?994187591828" TARGET=_blank>http://digilander.iol.it/simpson50/1_multimedia/simpson/gif_animate/06/homer_14.gif

http://www.geocities.com/fiream/RobsCarArtPa.html?994187591828</A>

 

Sombody's still using 640x480.

 

Actually it's 800 x 600. My monitor is pretty small though....

------------------
-Dan
-1990 3.1L RS
-Mods? no
-Slow? yes
-*Slowly* collecting parts for T5 swap

 

one tip... 88+ flywheels are way different then 87 down.

------------------
1972 Chevy Chevelle "Malibu"
Hooker Headers, Flowmaster 40 series mufflers, accel 8.8 wires,Edelbrock performer intake Edelbrock Carb, Torque Thrust "D" wheels
Click here for my Malibu information
In Memory of #3 Dale Earnhardt

 

Well, then the auto zone you work at must be a SUPER HAVE EVERTHING auto zone. Because I asked them and they said, NO. They can't even get one for me. So, you just go back to your goody perfect auto zone.

------------------
1984 Firebird SE
1985 Camaro z28 305 engine T-5 Five Speed Tranny, 92 Camaro Leather Seats Console, carpet everything. Soon to put in 700R4 and 427CI. (Hopefully.
To view my car go to:

http://geocities.com/jmboriss/bluecar.html

It is also for sale, please make me an offer. Thanks.

 

Sounds like an F-d up can't help the customer autozone to me... They HAVE access to these parts, just some of them are too stingey. You're not important to them so **** em !

I'd say go to the nearest U-pull-it yard and get one... at the very worst they'll have to pull it for you. There will be many more camaros than firebirds I'm sure, but it's the same part for both 2.8L T-5 F-bodies.

Once you go to a U-pull-it yard you'll never be the same... I'm goin back for a 4th time this month next friday or saturday cuz they just got another 'bird in the yard (number 2!)... was just there today, but it's gonna be a week til I get to take stuff


------------------
1984 Firebird - Daily driver, 305 LG4, 3.23 rear, T5 - Hurst short shifter, Edelbrock 600 CFM 1406 carb, Performer intake - Edelbrock Pro-Flow air filter, gutted cat, IROC 16x8 5 Spoke Wheels, AIWA bargain basement (from Sears of course) CD player, Eight-ball shift ****
Check out my ride here

"IT'S SNOWING! TO THE HIGH SCHOOL PARKING LOT!" - The Mustang and Firebird face off in the dead of winter.