testing open/close loop
Thread Starter
Senior Member
Joined: Nov 2001
Posts: 827
Likes: 0
From: Tenino, Washington
Car: 89 f-bird and some others
Engine: 3.4
Transmission: 700R4
Axle/Gears: 3.42
testing open/close loop
Do I need to put the jumper into A and B before I turn the key on and start it, or after it's started and running? I've tried searching, but just can't seem to find this part of the process, and it's simply been too many years since I last tested this.
I don't want to fry my ECM because the only other 302 I have doesn't let the tranny shift into OD, and the 165 never did work at all when I tried the swap.
I don't want to fry my ECM because the only other 302 I have doesn't let the tranny shift into OD, and the 165 never did work at all when I tried the swap.
Last edited by coolrimsatleast; Jan 19, 2015 at 01:02 PM.
Joined: Dec 2004
Posts: 16,808
Likes: 1,008
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: testing open/close loop
bye jumping a to b at the aldl enter field service mode
http://www.autozone.com/repairguides...96b43f8038edc8
http://www.autozone.com/repairguides...96b43f8038edc8
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
May 28, 2019 01:47 PM