Alippman
Thread Starter
Tech Boards / Tech / General Engine Yesterday 11:33 PM
Tuned Performance
How long are you waiting before the reprime ?
code 15 is probably a bad cts or corrosion on the cts plug.
Tech Boards / Body Yesterday 10:57 PM
If you have the rest of the factory GFX, that tells me you have the W68 appearance package. I don’t think it would look good combining the two designs, squared off look of the early front...
Tech Boards / TPI Yesterday 10:28 PM
I wouldn’t pressure wash it. Take a wet/dry vac and suck up all the dead leaves and debris and then spray if off with some cleaner and rinse. You don’t need to hit it with a pressure washer.
Many...
willgk03
Thread Starter
Tech Boards / TPI Yesterday 10:19 PM
lol, yeah. It has just above half a tank full in it right now
Tech Boards / V6 Yesterday 10:17 PM
Should be fine, I believe that's how it came on non-ac '88s... though I do think they had a bit more clearance. Maybe they had smaller WP pulleys, not sure. There is an AC delete dummy pulley...
Tech Boards / Electronics Yesterday 09:47 PM
gcj280
Cajun Tach Shop was the original designer and producer of the new tachometer circuit boards for 82-92- Camaros. They are a veteran owned business that doesn't outsource parts and manufacturing. They...
Tech Boards / Cooling Yesterday 09:19 PM
Já instalei alguns controladores ajustáveis para ventoinha elétrica e a melhor solução depende muito do espaço disponível no teu carro. A maioria das pessoas acaba por montar o controlador no...
Tech Boards / Electronics Yesterday 09:10 PM
Does your vom have a lower scale ?
DigitalDan3
Thread Starter
Tech Boards / Tech / General Engine Yesterday 08:46 PM
EDGE
I've been down this path more times than I care to remember. This is likely an EVAP issue. Does it happen right away or after it's been running a while. Is it worse when it's hot?
Tech Boards / Tech / General Engine Yesterday 08:30 PM
https://cimg9.ibsrv.net/gimg/www.thirdgen.org-vbulletin/131x229/image_3e339d97530329 3127024e6e412d603c72 2aeb8b.pngDisconnect that line at the top of the picture and gently blow compressed air through...