Third Generation F-Body Message Boards
Notched edge off top to clear the Sanden. Elongating both holes. Slow progress.
Notched edge off top to clear the Sanden. Elongating both holes. Slow progress.
0 2020/07/14 18:17:08
0 2020/07/14 15:13:01
Condensor and Sanden 4864 for hopefully big AC improvement!
Condensor and Sanden 4864 for hopefully big AC improvement!
0 2020/07/11 17:07:47
0 2020/07/06 15:26:13
0 2020/07/01 16:29:46
Poly mount = 45.9mm
Poly mount = 45.9mm
0 2020/06/26 17:18:16
Rubber mount = 52.5mm
Rubber mount = 52.5mm
0 2020/06/26 17:17:48
Pinion angle
Pinion angle
0 2020/06/26 17:15:15
Poly mount at trans. Pretty much 0*. I attached the angle finder to the bracket coming off at the end of the trans as it looked like the best flat spot.
Poly mount at trans. Pretty much 0*. I attached the angle finder to the bracket coming off at the end of the trans as it looked like the best flat spot.
0 2020/06/26 17:14:40
Purchased at OReilly's for $17, including tax
Purchased at OReilly's for $17, including tax
0 2020/06/26 17:13:28
The sail covers on my 85. Can't believe the condition!
The sail covers on my 85. Can't believe the condition!
0 2020/06/23 17:59:45
0 2020/06/23 17:59:27
0 2020/06/16 04:40:37
0 2020/06/15 08:24:32
0 2020/06/15 08:20:26
Mounted securely to the cassette player chassis
Mounted securely to the cassette player chassis
0 2020/06/15 08:18:41
Ground connection. This one was tough to solder in. Took scraping off the coating and getting down to bare copper and solder, plus lots of heat to get the factory solder to bond.
Ground connection. This one was tough to solder in. Took scraping off the coating and getting down to bare copper and solder, plus lots of heat to get the factory solder to bond.
0 2020/06/15 08:15:45
+12V to bluetooth module supplied by power going to cassette drive motor. Turns BT on when cassette inserted into player.
+12V to bluetooth module supplied by power going to cassette drive motor. Turns BT on when cassette inserted into player.
0 2020/06/15 08:14:24
DROK audio receiver from Amazon
DROK audio receiver from Amazon
0 2020/06/15 08:08:39
0 2020/06/15 07:57:59
Not a completely fair picture as the center console is not installed and faceplate is off, but the general idea is there. Just not what I am looking for in a radio.
Not a completely fair picture as the center console is not installed and faceplate is off, but the general idea is there. Just not what I am looking for in a radio.
0 2020/06/15 07:52:56
Few area where rust had formed. I ground away to clean metal and filled with JB Weld, primed and painted.
Few area where rust had formed. I ground away to clean metal and filled with JB Weld, primed and painted.
0 2020/05/04 12:50:32
0 2020/05/04 12:49:56
0 2020/04/26 19:37:18
Lower pin in place
Lower pin in place
0 2020/04/26 19:31:09
Upper pins installwd
Upper pins installwd
0 2020/04/26 19:30:07
0 2020/04/26 19:23:48
Finished re0air. Drilled hole for weatherstripping and painted.
Finished re0air. Drilled hole for weatherstripping and painted.
0 2020/04/26 19:14:59
After getting a light skin of bondo and sanded down. Read6 for paint.
After getting a light skin of bondo and sanded down. Read6 for paint.
0 2020/04/26 19:13:25
Patch welded in place. Took a friend of a friend kind of deal, but it turned out great!
Patch welded in place. Took a friend of a friend kind of deal, but it turned out great!
0 2020/04/26 19:11:58
Patch cut from sheet metal on the parts car. Shaped and formed to fit.
Patch cut from sheet metal on the parts car. Shaped and formed to fit.
0 2020/04/26 19:09:45
Odd spot for rust to form. I think water got trapped behind the weatherstripping.
Odd spot for rust to form. I think water got trapped behind the weatherstripping.
0 2020/04/26 19:07:13
Tried to get a good shotnof my air hammer with chisel, definitely tough in a tight space.
Tried to get a good shotnof my air hammer with chisel, definitely tough in a tight space.
0 2020/04/26 18:44:38
Tucks nicely in above the bracket and zip tied in place.
Tucks nicely in above the bracket and zip tied in place.
0 2020/04/24 07:43:20
0 2020/04/24 07:41:00
0 2020/04/24 07:32:33
Cleaned the contacts with 0000 steel wool and just a slight dab of grease on the shaft.
Cleaned the contacts with 0000 steel wool and just a slight dab of grease on the shaft.
0 2020/04/20 20:14:09
New voltage regulator peaking out at the bottom.
New voltage regulator peaking out at the bottom.
0 2020/04/20 20:11:40
Battery post that needs to be unscrewed to allow the rectifier to be removed.
Battery post that needs to be unscrewed to allow the rectifier to be removed.
0 2020/04/20 20:09:25
Keep track of the bolts as the one in back is longer than the front one. These two hold a little doohickey in place. Technical term.
Keep track of the bolts as the one in back is longer than the front one. These two hold a little doohickey in place. Technical term.
0 2020/04/20 20:07:39