Third Generation F-Body Message Boards
Adapter Kit
Adapter Kit
0 2024/12/08 17:55:15
Transmission with bellhousing installed
Transmission with bellhousing installed
0 2024/12/08 17:56:49
You can see in this picture that the mount is actually in front of the cross member. I ended up welding a square tube piece on the front side to get it to mount. I will upload pictures later.
You can see in this picture that the mount is actually in front of the cross member. I ended up welding a square tube piece on the front side to get it to mount. I will upload pictures later.
0 2024/12/08 18:04:47
Need to drill out the spot welds for the auto shifter mount.
Need to drill out the spot welds for the auto shifter mount.
0 2024/12/08 18:07:30
You can see through the shifter grommet hole the top left corner of the shifter mount. That is where I started cutting with the body saw and making small cuts.
You can see through the shifter grommet hole the top left corner of the shifter mount. That is where I started cutting with the body saw and making small cuts.
0 2024/12/08 18:08:17
Opening is almost complete and you can see the shifter mount.
Opening is almost complete and you can see the shifter mount.
0 2024/12/08 18:08:21
Shifter temporarily installed to see fitment with plastics.
Shifter temporarily installed to see fitment with plastics.
0 2024/12/08 18:08:24
Shifter in relation to auto shifter bezel
Shifter in relation to auto shifter bezel
0 2024/12/08 18:12:00
Shifter location.
Shifter location.
0 2024/12/08 18:12:03
Transmission up and mounted
Transmission up and mounted
0 2025/02/09 10:09:19
Y-Pipe in you can see still is the lowest point. I do want to re-do that to prevent scraping.
Y-Pipe in you can see still is the lowest point. I do want to re-do that to prevent scraping.
0 2025/02/09 10:09:21
More angles.
More angles.
0 2025/02/09 10:09:23
With driveshaft in. Had to shorten the stock driveshaft by about 1/2" to allow it to be put in. Local shop did it for around $120.
With driveshaft in. Had to shorten the stock driveshaft by about 1/2" to allow it to be put in. Local shop did it for around $120.
0 2025/02/09 10:09:25
Need about a 4" offset from location where it comes through tunnel
Need about a 4" offset from location where it comes through tunnel
0 2025/04/18 18:59:20
Location of shifter without plate removed
Location of shifter without plate removed
0 2025/04/18 19:00:38