Had this intake hat made when i was running the wet shot on the car. Used a single fogger setup with this kit and it worked great. Works well as a tbi cold air intake. Air box bottoms are gutted as well. The intake hat has a hole drilled in it to accept a grommet and the air intake temp sensor as well.


100$ obo + shipping

 

How much shipped to 90650 and do you have the filters

 

u gutted out the bottom i always wanted to see how people did this that is a pretty cool setup you got there anyway to see a pic of the bottom portion of the tpi air intake?

 

Sure can, ill get some shots of the bottom later today. Just has the bottom halfs where it blocks airflow cut off, works good. I even dyno'd the car and it made 180/240 ft lbs and barely gained anything from removing the intake completely, i think it was like 3-6 hp..so it flows well. The filters are included, they are just paper filters though, have like maybe 1000 miles on them. Shipping will be around 25$ b.c of the size of the box ill need to use, doesn't weigh very much but its bulky haha.

 

Ok can you please pm me the lowest you will sell it for shipped to me

 

i dont really want to go any lower then 125$ shipped as the intake hat cost me a decent chunk of change to get made when i had it done.

 

Alright then I Am going to think about it and get back to you

 

bump bump

 

so the bottom side is just cut out square like the filters correct? nice setup im passing though, thanks.

 

I'm sorry I am gonna pass since I am gonna buy an intake and a cam for my 350 instead. Good luck with the sale.

 

ttt

 

100$ shipped

 

ttt

 

Make an offer