Open House this Saturday (9-21-2013) from Noon until 4:00PM.
Come on out and take a look at everything.

I've got to make some room so a bunch of stuff has got to go.

If anyone would like to come out to my shop in Stafford (77477) you are welcome to look around. The following pictures and descriptions are about 75% of what needs to go. The rest is misc. little stuff that came off of the various third-gens I parted out over the years.

What hasn't sold in two weeks will most likely go in the dumpster, so if you are interested in something place a bid. You might get it cheap. Any semi-reasonable offer will be accepted on the spot.

All items must be picked up.
If you have any questions just ask.

Sold #1 below
Rusty headman long tube headers $50
84 Z28 front and rear sway bars $20 each or $30 for both.

#2
Camaro Tail lights, no cracks, good condition (just dusty) with small wiring harness $50/pair

92' Z-28 rear bumper (blue) small crack $40

front right Fender, good condition (no dents) $50

cloth rear seats bottoms(two)+back make offer

I also have not pictured:

two hatches (Sold 1)

Sold - one factory 91-92 High Rise hatch wing (Blue)

Sold harness - A second (MAF) TPI system with "painless" harness and computer $200

Victor Junior small block Chevy intake manifold, very good condition $125

Factory 2 barrel TBI intake manifold (88 Chevy truck?) $10

Carbs (Holley 650 double pumper + a couple of other holleys), distributors (HEI, Mallory+?), radiator electric fans(complete 92 Z-28 dual fan setup+ others), flex fans, several oil/tranny coolers, misc. exhaust parts

Lots more, come take a look.


Thanks for looking.

 

#1 and #2

'92 Z-28 dash board with wiring harness (door part cut) make offer

#3
TPI Intake/throttle body/ fuel rails/ injectors(unknown condition) $75

 

#1
insulated AC evaporator housing W blower motor, no cracks or holes $50
(sold)

#2

Blue '92 Z-28 rear bumper shown earlier

#3
Center console bottom/sides

door threshold pieces

inside lower hatch trim

I have a lot of interior pieces that are not shown

 

#1

Center console shifter covers
'92 Z-28 gauge cluster trim
AC evaporator (unknown condition)

#2
More of the same

#3
Center console cover w/ switches

hatch spoiler side pieces (center section not pictured, but in good condition) Black, I also have one white side piece (second white side piece may be around someplace)

 

#1
Better picture of center console top

Center Console radio/ac cover (pictured in console)

#2

Sold - 91-92 chin spoiler Good condition $100

center section of black hatch spoiler ($50 for all 3 pieces)



***** check first post for updates

 

Sold - 91-92 rear spoiler

Edelbrock Victor Jr.

650 double pumper, fans and distributors

 

2 hatches, 55 Gal plastic barrels,

5 tail lights (2 different styles, 2.5 sets) (sold pair pictures here, still have another pair)

Sold - '82 Crossfire Z-28 working hood scoops

 

Sold - Bottom of '82 Crossfire Z-28 working hood scoops

complete Tuned Port Injection (2 complete sets) + an extra base plate with the old style angled center bolt holes

Sold - Painless wiring harness and computer for TPI

 

Lighted rear view mirror+assorted AC hoses

BMR ram air scoops designed to fit in the holes in the front bumper of a Z-28, one with two holes (brake) one with one hole (intake)

Plastic racing seat with vinyl cover and adjustable brackets, never used, like new except for the dust.

This is all just a sample of all the third gen staff I've collected over 31 years.
I need to make some room, so make an offer on anything you are interested in.

 

Hey where's your shop located? Address

 

It is in a storage unit near Alt 90 and Murphy.

 

Ok. Can I come by sometime? This evening? Or when would be good? I live like 5 min from there.

 

do u have a Camaro font fog light grille shell? iroc fog light grill shell

 

Do you mean the insert that goes in the hole in the bumper?
No I don't think that I have any of those.

 

What condition are the hatches in?

 

Good. The glass is pretty clean and not scratched up.
One has a white bottom panel with holes for a spoiler (spoiler not included).
The bottom panel for the other is the blue one attached to the high rise '92 spoiler (sold separately).

Sold Blue spoiler and hatch - one hatch remaining

 

I'll be out at my shop this Saturday from Noon until 4:00 PM.
After that I'm going to the HFB meet at Texadelphia on Westhiemer.

Come on out and have a look.
PM me for location and my phone number.

 

more pictures that people have asked for of specific parts:

 

and more:

 

Wiring harness and CFI hood scoop are sold.

 

How much do you want for the 650 double pump? willing to ship?

 

$150 shipped.

 

Do you still have the MAF) TPI system with "painless" harness and computer

 

Sorry, the TPI harness and computer are sold. I still have two TPI intakes.
The '82 CFI hood scoop is sold.
The '92 chin spoiler is sold.
Two of the 5 tail lights are sold.
AC evaporator housing is sold.

 

Well dayum nevermind then

 

^

 

still got one of the tpi intakes? what all comes with them?

 

I still have both manifolds (base, runners, plenum) they include the throttle body, injectors, fuel rail and perhaps some sensors...I'll have to check.

 

the only sensor i would need is a maf. is it for newer style heads and whats the price tag?

 

No luck there...

I have 2 base plates for the newer heads and one for the older.

$75.00 for the base, runners, plenum, T.B., injectors (for what there worth) and fuel rails.

 

Do you still have the high rise spoiler and a hatch for sale??

 

I do.
How does $125 for the spoiler $175 for both sound?

 

Sounds good. Are they still in the same place?

 

Yes.
Do you want to go meet me out there this afternoon (Sunday)?

 

Sorry. I don't check my email until now. Can we meet some time next week?

 

Sure, just let me know a day or so in advance.

 

what #injectors are they eric?

 

I don't really know.
I believe that one set came off of a 350, but I don't know which.

 

OK, last call on this stuff.
If there is anything that you want, speak up now.
No reasonable offer will be refused.

 

Hey sorry I've taken too long to contact you. I can meet you tomorrow to get the spoiler and hatch if that's ok with you.

 

Do you still have any of this stuff???

 

What are you looking for?

 

Yes.
About 1/3 of it.
I still have a couple of TPI setups (- harness, computer and most sensors).

 

I just updated a bunch of posts to say what is sold and what isn't.

 

Im definitely interested in the TPI setup... Preferably one that came off of a speed density setup if you have one.

 

I don't think that either is SD.

I have 2 straight (center manifold) bolt base plates and one, old style, angle bolt base plate.

Otherwise, I think that one was a 9th injector (1985) version and the other was from 1987 or 88.