Please close thread

Reply Subscribe

Thread Tools

Search this Thread

09-25-2016, 01:53 PM

bubbaz28

Member

Thread Starter

Join Date: Feb 2014

Posts: 162

Likes: 24

Received 2 Likes on 2 Posts

Car: 1983 Z-28

Engine: 305 LG4

Transmission: 5-speed

Please close thread

Reposted in electronics

Attached Thumbnails

Last edited by bubbaz28; 09-29-2016 at 07:38 PM. Reason: Reposted in more appropriate forum

Reply Like

09-25-2016, 02:50 PM

Tibo

Supreme Member

iTrader: (15)

Join Date: Jun 2003

Location: Desert

Posts: 5,025

Likes: 1

Received 76 Likes on 66 Posts

Car: 1991 Z28 Vert

Engine: 383 single plane efi

Transmission: T-56

Axle/Gears: 8.8 with 3.73s

Re: fuel sender unit- insulation coming off of wire

Solder in a new wire section. Don't use electrical tape for sure. I'm not even sure if heat shrink would hold up gas though. I would repost this in electronics.

Reply Like

09-29-2016, 07:31 PM

bubbaz28

Member

Thread Starter

Join Date: Feb 2014

Posts: 162

Likes: 24

Received 2 Likes on 2 Posts

Car: 1983 Z-28

Engine: 305 LG4

Transmission: 5-speed

Re: fuel sender unit- insulation coming off of wire

Thanks Tibo. I will try to repost in electronics. My only worry about soldering a different wire in is, will that wire's insulation hold up to the Ethanol exposure?

Reply Like