Alternative Port EFI IntakesThis board is for tech discussions and questions about aftermarket port EFI such as the HSR, MR, SR, BBK, FIRST, etc.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
well i was looking into upgrading my intake since i have full exhaust and tpi sucks so i was gonna just get some ported tpi parts because i thought stealthram cost over $1000. Yesterday i went on thunderracing and seen this
61-7540 Holley StealthRam Intake Manifold & Base Plate. (Stock Fuel Rails not compatible, must use Holley Fuel Rails) $299.99
Are these the only two things i need to buy to install the holley stealth ram on my l98?
also id like to see pics of hsr installed on any thirdgen.
__________________ Iroc MODS
Air/Fuel- Moddified Holley 650 Dual Feed electric choke vacuum secondary carb, Holley Street dominator high rise intake, mallory 3 port fuel pressure regulator, 14x3 Summit open element air cleaner. 6psi fuel pressure
Ignition- Summit HEI dist, Summit 8.0mm wires. 8 degrees of timing
Exhaust- Hooker 2055 headers and y-pipe, 3" MAC cat delete pipe, 3" Hooker catback
Transmission- S-10 2025 stall torque converter, Superior shift kit w/ vette servo, Energy suspensions mount, B&M super cooler.
Cooling- 180 hi flow mr.gasket thermostat, 195 jet fan switch.
Suspension- UMI tubular non adjustable lower control arms
Well for the Stealth ram, and intake fittings, I had some extra AN fittings and they were Earl, and so was the stainless hose. U will also have to change the water neck, you'll have a lot to choose from, but certain ones can fit the stock hose up top. But you'll fit under a camaro hood, but not a stock firebird one without cutting it up a little inside the bracing area, under the hood in the center.
