Accel MPFI Throttle Body Linkage ???
04-03-2011, 09:21 PM
#1
Banned
Thread Starter
iTrader: (4)
Join Date: Dec 2000
Location: ILL
Posts: 861
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Pontiac TA
Engine: 383
Transmission: 700R4
Axle/Gears: 3.70
Accel MPFI Throttle Body Linkage ???
I'm in the process of switching my MPFI throttle body from Edelbrock 1000 cfm to the Accel 1350. My question is in regard to the studs needed for the throttle cable and TV cable. I have the studs from my Edelbrock but the thread size on the Accel is smaller and I prefer not to have to drill out and tap if I don't have to. Anyone been through this before and know where to get direct fit studs?
04-04-2011, 07:34 PM
#2
Member
iTrader: (3)
Join Date: Jul 1999
Location: Latham NY USA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Formula
Engine: 350
Transmission: T-56
Axle/Gears: 10 Bolt 3.23
Re: Accel MPFI Throttle Body Linkage ???
I have the same throttle body. I used a stud from an edelbrock carb, I may still have the package for a part number. Not sure about the TV cable though
04-04-2011, 08:10 PM
#3
Member
iTrader: (3)
Join Date: Jul 1999
Location: Latham NY USA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Formula
Engine: 350
Transmission: T-56
Axle/Gears: 10 Bolt 3.23
Re: Accel MPFI Throttle Body Linkage ???
Edelbrock 8009 77chevy throttle cable adapter. Picked it up at pep boys.
04-05-2011, 07:52 PM
#4
Banned
Thread Starter
iTrader: (4)
Join Date: Dec 2000
Location: ILL
Posts: 861
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Pontiac TA
Engine: 383
Transmission: 700R4
Axle/Gears: 3.70
Re: Accel MPFI Throttle Body Linkage ???
Mark - picked up the Edelbrock part tonight. Glove fit. Thanks for the tip!
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
06-13-2021 01:13 PM
mdtoren
Tech / General Engine
0
08-16-2015 05:45 PM
