orb of power vacuum ball
#1
Senior Member
Thread Starter
orb of power vacuum ball
the vacuum ball under the front left fender well (below battery tray)...........how does it actually attach on, does it attach to a bracket or just to the battery tray itself? I am swapping to factory cruise and am wondering if i need to get a bracket to mount it.
thanks.
thanks.
#2
Member
iTrader: (1)
Join Date: Apr 2007
Location: Sioux Falls, SD
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 Firebird
Engine: SBC 383/88BW
Transmission: Built 700R4
Axle/Gears: Moser 9in/3.55
Re: orb of power vacuum ball
I can take pictures if you want, it attachs right through and onto the cruise unit above. That is on my 85 firebird, my 91 seems a bit differen't tho
#3
Supreme Member
iTrader: (3)
Join Date: Jun 2000
Location: CT
Posts: 1,680
Likes: 0
Received 2 Likes
on
2 Posts
Car: Used to drive a camaro
Re: orb of power vacuum ball
There are tapped tabs if you will on the driver side of a camaro and provisions on the pass side also. If you're using the pass side you'll need clips simliar to the ones (not the same size) that attach the fenders. You can also just use a nut,washer, bolt to fasten it as well, just don't crank down on tightening and you won't crack the plastic.
#4
Senior Member
Thread Starter
Re: orb of power vacuum ball
That would be cool if you could. But attaches to the cruise unit on an 85? Or are you referring to a carbed car? I just realized that, battery is on the passenger side........but i still though 85-up all had the cruise module mounted on the fender beside the washer tank?
Thread
Thread Starter
Forum
Replies
Last Post
sailtexas186548
Problems / Help / Suggestions / Comments
2
08-24-2015 10:11 PM
mdtoren
Tech / General Engine
0
08-16-2015 05:45 PM