Hood shocks
#1
Junior Member
Thread Starter
Join Date: Aug 2017
Location: Virginia
Posts: 39
Received 0 Likes
on
0 Posts
Car: 1988 Camaro IROC Z
Engine: 427 Stroker
Transmission: 700 R4
Axle/Gears: Moser Street axles and 410 Yukon
Hood shocks
I know this may sound stupid but which way is the hood shocks supposed to go the ones I have on now the Chrome Rod is attached to the hood and the cylinder attached to the fenders I've seen some are the other way around will it hurt anything either way or should they be a specific way thanks in advance
There's a picture of my 427 Stroker
There's a picture of my 427 Stroker
The following users liked this post:
88bullet (09-13-2019)
#3
Junior Member
Thread Starter
Join Date: Aug 2017
Location: Virginia
Posts: 39
Received 0 Likes
on
0 Posts
Car: 1988 Camaro IROC Z
Engine: 427 Stroker
Transmission: 700 R4
Axle/Gears: Moser Street axles and 410 Yukon
Re: Hood shocks
Thanks nice camaro ...I thought they were supposed to be the other way wonder if it hurts it any being the other way
#4
Supreme Member
iTrader: (7)
Join Date: Mar 2000
Location: Orange, CA
Posts: 5,675
Likes: 0
Received 108 Likes
on
66 Posts
Car: '90 Trans Am-12.45@110.71
Engine: 355 w/AFR 195's Elem. 400/430 HP/TQ
Transmission: Tremec T-56
Axle/Gears: 12 Bolt 3.73
Re: Hood shocks
Cylinder to the hood rod to the fender is the proper way.
The following users liked this post:
88bullet (09-13-2019)
Thread
Thread Starter
Forum
Replies
Last Post