Thread Sealant
05-17-2012, 05:58 AM
#1
Member
Thread Starter
Join Date: Sep 2008
Location: Atlanta
Posts: 178
Likes: 0
Received 1 Like
on
1 Post
Car: 1992 Z28
Engine: 305
Transmission: 5 speed
Axle/Gears: 3.42
Thread Sealant
I'm going to replace the fan control switch in my car this weekend. Was wondering if I need to use any thread sealant or teflon tape? It says nothing about it in the instructions and it is a hypertech switch.
05-17-2012, 07:36 AM
#3
05-17-2012, 08:27 AM
#4
Member
Re: Thread Sealant
I use the permatex (or what ever the name is) thread sealant on just about anything that gets threaded into a water jacket. never have i ever had a block leak.
05-17-2012, 08:56 AM
#5
Supreme Member
iTrader: (2)
Join Date: Mar 2002
Location: West Houston, Tx.
Posts: 1,029
Likes: 0
Received 1 Like
on
1 Post
Car: 1991 Z28
Engine: 355 TPI
Transmission: 700r4
Axle/Gears: 9 bolt disc / 3:27
Re: Thread Sealant
I've used that before. Just remember that the sensor needs to ground to the block. You don't need a whole lot just enough to seal.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
05-17-2020 10:44 AM
355tpipickup
Tech / General Engine
5
09-28-2015 05:50 PM
