SD vortec base question
#1
Member
Thread Starter
Join Date: Jun 2014
Location: Montana
Posts: 393
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1986 Trans AM WS6
Engine: 383 Vortec TPI, PUTS SMILES ON FACE
Transmission: PATC LVL 3 Raptor Transmission
Axle/Gears: 3.27 POSI 9 BOLT
SD vortec base question
98 vortec block from a suburban.......
Turned it into a 383.. my question is, on the front do i need to put in the hose going from the water pump to the intake?
I think its a bypass something rather.....
Turned it into a 383.. my question is, on the front do i need to put in the hose going from the water pump to the intake?
I think its a bypass something rather.....
#2
Member
Join Date: Aug 2004
Location: Ottawa
Posts: 202
Likes: 0
Received 10 Likes
on
9 Posts
Car: 86 IROC
Engine: Twin turbo L31 HSR
Transmission: 700R4 w ProBuilt
Axle/Gears: 9 bolt 4.11
Re: SD vortec base question
I've got the same block, with a vortec based HSR intake, here's a pic of that bypass hose connected so I'd say yes.
#3
Member
Thread Starter
Join Date: Jun 2014
Location: Montana
Posts: 393
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1986 Trans AM WS6
Engine: 383 Vortec TPI, PUTS SMILES ON FACE
Transmission: PATC LVL 3 Raptor Transmission
Axle/Gears: 3.27 POSI 9 BOLT
Re: SD vortec base question
Ok, thanks... when its all warmed up how firm are your radiator upper and lower hoses, i can squeeze them but not too much they are pretty hard.
#4
Member
Join Date: Aug 2004
Location: Ottawa
Posts: 202
Likes: 0
Received 10 Likes
on
9 Posts
Car: 86 IROC
Engine: Twin turbo L31 HSR
Transmission: 700R4 w ProBuilt
Axle/Gears: 9 bolt 4.11
Re: SD vortec base question
Can't say as I've checked the hoses but I have changed the temp sensor in the block and converted to Autometer Pro Comp Ultralite gauges ( so better than stock "guess the temp" ones) and the car runs no more than 200 degrees.
Brian
Brian
Thread
Thread Starter
Forum
Replies
Last Post
Doppelganger
Tech / General Engine
18
03-08-2024 06:56 PM