auto to manual in 16147060 pcm
03-16-2004, 11:38 AM
#1
Member
Thread Starter
Join Date: Nov 2001
Location: Somerset,KY,USA
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 IROC
Engine: 305 TPI
Transmission: Auto
auto to manual in 16147060 pcm
Is this possible? I am new to diy tuning and can't find any flags for manual trans. Could I change the trans settings so the pcm doesn't look for it? I am running the pcm in a Jeep that has a manual trans. The pcm is setting 4 different codes for the trans because it isn't there. Would I be better off changing to a 1227747 pcm? How hard would this be? Would it be a simple pin change? I have searched and can't find any info on this.
Thanks
Thanks
03-16-2004, 12:36 PM
#2
Supreme Member
Join Date: Jun 2000
Location: In reality
Posts: 7,554
Likes: 0
Received 1 Like
on
1 Post
Car: An Ol Buick
Engine: Vsick
Transmission: Janis Tranny Yank Converter
If at all possible, I'd suggest keeping the 7060. It's a nice PCM. It also has the faste ALDL so you can data log really meaningful info..
As far as the trouble codes, that's just a matter of resetting some diagnostic flags.
If you're using the Tunercat Editor, then writting him, will probably get the addition flags added to the .tdf.
As far as the trouble codes, that's just a matter of resetting some diagnostic flags.
If you're using the Tunercat Editor, then writting him, will probably get the addition flags added to the .tdf.
Thread
Thread Starter
Forum
Replies
Last Post
