mikobu3

ok guys ,

i got all of the prom equipment from craig moates , i am using a at29c256 chip , trying to get the arap bin to work on my highly modded 1986 305 tpi ,

everytime i burn a chip and put in the car the fan comes on and the ses light comes on and stays on , i cannot scan the codes , i been trying all kinds of bins no go

only thing i can think of is my starting addresses can that be?

thanks

Mangus

Been covered a thousand times.

mikobu3

i don;t see were that says what to do

been looking for 3 months ,

would the instructions be on moates site?
thanks

Morley

In the .bin editor under "flags" switch the fan operation ( A/C Pressure Switch Specification Byte) to N/O (in winbin put a check mark in that box)

Mangus

Refine your search techniques:

https://www.thirdgen.org/techbb2/sho...ght=16k+29C256

mikobu3

thanks mangus , i asume the burn1 works the same way as pp2 , maybe thats my problem i will get to it this weekend
thanks

Mangus

Works the same way. Put your 29C256 in the ZIF, load your (16k) bin, set your chip start address to 4000, end address to 7FFF, buffer start to 0, buffer end to 3FFF, and burn.

mikobu3

so the at29c256 is a 16k chip , i have a guy helping me out and he switched the arap bin to 32 k

mangus ,, should i just get a fresh copy of the arap bin and do what you say up top , all i want for now is to get the car to start with out fan on and ses light on , so i can scan it

thanks

Mangus

29C256 chips are 32 kilobyte. $6E bins are 16 kilobyte. If your friend has a $32k $6E bin, he's either stacked it or padded it to fit on a 32k chip without having to change the chip offsets.

va454ss

iTrader: (1)

Is Craig's website down?

Tried several times today without success.

mikobu3

i can not get the 32k chip to work in my car thats what i;m trying to say , fan comes on , as soon i start it the ses light comes on and it burns lots of fuel , after that i cannot scan the codes ,

maybe the burn 1 only can do 16k chips , no clue here

Mangus

Yeah, his site is down temporarily (hopefully only a day or two) while he transfers ISPs.

Mangus

Yes, get a fresh copy and do what i outline above. The BURN1 can burn anything you'd need to for DIY PROM burning. Its not the hardware.