Cant get flags to come up?
#1
Cant get flags to come up?
Hi guys,
Ive downloaded tunerpro and winbin, and when i open up the bin file from my chip (8746 ecm) i cant see anything but the graph table in either program? The flag window is empty, too.....am i supposed to go in and designate the flags manually (by choosing the line in the hex editor) or what? Im using Prevost's ecu file and my bin off of my chip. I downloaded the ecu file from moates....is it possible i got a bad file? Or maybe im just cornfused........
By the way, i cant see the flags in any of the other bins i downloaded (anlu) either. The page that comes up in Winbin right after you choose your bin and ecu file is blank (no flags)???
Help anyone? JP? Mangus?
Ive downloaded tunerpro and winbin, and when i open up the bin file from my chip (8746 ecm) i cant see anything but the graph table in either program? The flag window is empty, too.....am i supposed to go in and designate the flags manually (by choosing the line in the hex editor) or what? Im using Prevost's ecu file and my bin off of my chip. I downloaded the ecu file from moates....is it possible i got a bad file? Or maybe im just cornfused........
By the way, i cant see the flags in any of the other bins i downloaded (anlu) either. The page that comes up in Winbin right after you choose your bin and ecu file is blank (no flags)???
Help anyone? JP? Mangus?
#2
I just opened the $6e file and bin that came with tunerpro, and everything came up like it was supposed to. I know im not supposed to use the $6e definition for an 8746.....so what gives?
Thread
Thread Starter
Forum
Replies
Last Post
Zachattack0925
Tech / General Engine
2
08-12-2015 09:54 PM
Zachattack0925
Transmissions and Drivetrain
4
08-12-2015 09:52 PM
FAST RS
Auto Detailing and Appearance
54
07-06-2003 12:23 AM