Tunerpro Road Speed Constant
#1
Supreme Member
Thread Starter
iTrader: (3)
Join Date: Jun 2000
Location: CT
Posts: 1,680
Likes: 0
Received 2 Likes
on
2 Posts
Car: Used to drive a camaro
Tunerpro Road Speed Constant
I can't find what these should be:
Road Speed Sensor Constant (KSPDSEN) I thought it was supposed to be 4,100
Road Speed IP Pulse Divisor (KSPDDIV) Right now it's zero
The electric VSS I have has the right gear for a 3.73 rear end
Any help is appreciated, my speedo and tunerpro are waaaay off.
Road Speed Sensor Constant (KSPDSEN) I thought it was supposed to be 4,100
Road Speed IP Pulse Divisor (KSPDDIV) Right now it's zero
The electric VSS I have has the right gear for a 3.73 rear end
Any help is appreciated, my speedo and tunerpro are waaaay off.
#2
Supreme Member
Thread Starter
iTrader: (3)
Join Date: Jun 2000
Location: CT
Posts: 1,680
Likes: 0
Received 2 Likes
on
2 Posts
Car: Used to drive a camaro
Re: Tunerpro Road Speed Constant
Well, I believe I found the correct value for the pulses which should be 4000 not 4100. But what about the Road Speed IP Pulse Divisor (KSPDDIV)??
#3
Senior Member
Join Date: Nov 2006
Location: Camden, MI
Posts: 672
Likes: 0
Received 1 Like
on
1 Post
Car: 1985 IROC-Z28
Engine: LB9
Transmission: 700R4
Axle/Gears: 3.73
Re: Tunerpro Road Speed Constant
IIRC, in 8D, a pulse divisor of 0 means divide by 1(aka, no change).
what does the datastream say compared to the speedo?
what does the datastream say compared to the speedo?
Thread
Thread Starter
Forum
Replies
Last Post