Easy DIY electronic turn signal flasher.
09-30-2007, 08:16 PM
#1
Member
Thread Starter
Join Date: Jun 2002
Location: Vermont
Posts: 344
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 W69 Special Edition
Engine: 2.8/ECM/Int/Exh
Transmission: T5
Axle/Gears: 3.42 posi
Easy DIY electronic turn signal flasher.
Pulled the flasher socket from my 97 Grand Prix, and installed one of my modified flasher modules with adjustable timing. Installs in 5 minutes, with no alterations to the factory Firebird wiring.
Crimp a 1/4" male spade to the blue and violet wires of the new socket, and insert the tabs into the F-body's stock 2-pin thermal flasher socket. In my case, blue to blue, violet to violet. Be sure to observe polarity if your socket differs. Ground the black wire, and enjoy turn signals that don't vary with engine load!
Crimp a 1/4" male spade to the blue and violet wires of the new socket, and insert the tabs into the F-body's stock 2-pin thermal flasher socket. In my case, blue to blue, violet to violet. Be sure to observe polarity if your socket differs. Ground the black wire, and enjoy turn signals that don't vary with engine load!
Thread
Thread Starter
Forum
Replies
Last Post
Fronzizzle
Suspension and Chassis
6
03-18-2019 08:29 PM
adjustable, body, build, diy, diyelectronic, easy, electronic, flasher, pin, signal, signals, thermal, turn, turnsignal, wiring
