cs144 alternator conversion ?
02-22-2009, 10:10 PM
#1
Member
Thread Starter
Join Date: Aug 2006
Location: Mt.Holly, NC USA
Posts: 429
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Camaro, 1986 S10, 2000 Harley
Engine: LS6
Transmission: T56
Axle/Gears: 3.75 9" ford trac loc
cs144 alternator conversion ?
Hi guys, I am in the process of converting a cs130 alternator to cs144. I have read that you need a resistor in the "switch on" wire, terminal L . I also read that these alternators use the same voltage regulators. So my question is will I need this resistor for my conversion? Car is 1988 camaro,TBI engine. By the way, alternator is off of a 1993 cadillac fleetwood, the connector has two wires, camaro connector has three wires. Does the third wire take care of this? Also camaro has volt meter , caddy does not. Thanks in advance, Dean!
Thread
Thread Starter
Forum
Replies
Last Post
raymondandretti
Electronics
1
09-27-2015 06:43 PM
