ElectronicsNeed help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
Hi guys man I need help, I went to start the car with the key got nothing, with the ignition turn on, No radio,No wipers,no turn singles, But when I stick the key in the ignition switch the buzzer will ring. When I turn key acc still no radio or power going to it. I have push botton start switch that turns the starter over that is working find. Is there a fuse some where man if so I can't find it. Or could it be a bad switch, The hazzerd lights switch work on the steering column. I never play with the wiring to a key switch before.
The car is a 82 camaro with a tilt steering wheel.
Wiring for the IGN is on the top of the column under the dash. I wouldnt bother replacing it until you rule out that you're getting power to the inside
Im unsure for older cars, but newer ones get power to the dash harness by the C100 connector. It has 2-4 large red wires that get power from the battery but are ran thru fusible links. These are located on the starter or a power junction block near the battery. If a fusible link blows the IGN switch gets no power so all your electronics are dead
I got power in the steering column the buzzer sounds when I turn the key in the ignition switch and the hazard lights work when I pull on them. But nothing when I turn the key...
Last edited by jag327; 08-29-2009 at 01:58 PM.
Reason: pics
Man what did the electrical gremblins come out this week on everyone..lol
Jag, If you find out that the switch is bad I have them in stock for your car. Their pretty short money.Just give me a shout if you have any questions.
I found the problem a fuse link wire man pull everything lose, the funny on my tester I'm still getting 12 volts through it. I open up the wiring only 3 silver wires are together and the rest burt up... I'm ok now...
i am having the same problem i did a tune up and the car turns over but does not start or turn over before that the car ran fine and now it doesent run no lights work at all all the plugs are on the right firing order need help
