pull down hatch
#1
Member
Thread Starter
Join Date: Dec 2007
Location: mattoon illinois
Posts: 199
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92camaro,86 camaro
Engine: 355
Transmission: 700r4
pull down hatch
im rewiring my car and i have the pull down hatch and i want to know if i t is easyer to rewire it or replace it with a non pull down?
#2
Supreme Member
iTrader: (8)
Join Date: Jul 2001
Location: New Boston, IL, USA
Posts: 3,204
Likes: 0
Received 6 Likes
on
6 Posts
Car: '90 Formula 350
Engine: 383 SBC
Transmission: ProBuilt S/S 700-R4 & ACT 9" Stall
Axle/Gears: 10 bolt 3.23
Re: pull down hatch
If you have an '86 pulldown unit. Overall the wiring is pretty simple. Are you rewiring after a fire or rodent issue?
http://www.top-downsolutions.com/Doc...structions.pdf
This guide should be more than enough to get you through it with pics and stuff. It covers rebuilding the motor but between it and your general Haynes or Chilton Wiring diagrams it shouldn't be too bad.
http://www.top-downsolutions.com/Doc...structions.pdf
This guide should be more than enough to get you through it with pics and stuff. It covers rebuilding the motor but between it and your general Haynes or Chilton Wiring diagrams it shouldn't be too bad.
#3
Member
Thread Starter
Join Date: Dec 2007
Location: mattoon illinois
Posts: 199
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92camaro,86 camaro
Engine: 355
Transmission: 700r4
Re: pull down hatch
well thanks for the link but i know my pull down work cuz it was working before i started rewiring the car.
my problem is that that all the wires that go to the back of the car end at the side of the driver seat. my switch is not wired up or anything i have no wires under my dash or a fuse block.
my problem is that that all the wires that go to the back of the car end at the side of the driver seat. my switch is not wired up or anything i have no wires under my dash or a fuse block.
Thread
Thread Starter
Forum
Replies
Last Post