need starter help
#1
Member
Thread Starter
Join Date: Nov 2010
Location: Sylmar, So-Cal
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 firebird bone stock for now
Engine: 2.8L V6
Transmission: 700R4
Axle/Gears: B.W 9Bolt 3.27 Posi
need starter help
plugged in a new solenoid and my car doesnt crank. the starter gets power and i tested it outside the car to make sure i didnt need a new motor and it was fine. starters grounded aswell so i dont see whats going on.
anything i can check??
i tested it with a tester light only not with a dmm yet. ill do that tomorrow hopefully.
thanks -Aaron
anything i can check??
i tested it with a tester light only not with a dmm yet. ill do that tomorrow hopefully.
thanks -Aaron
#2
Member
Thread Starter
Join Date: Nov 2010
Location: Sylmar, So-Cal
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 firebird bone stock for now
Engine: 2.8L V6
Transmission: 700R4
Axle/Gears: B.W 9Bolt 3.27 Posi
Re: need starter help
ok so i finally got a chance to check the voltage on the starter and im getting 8 volts at the starter. does that seem right?
did a battery load test and the voltage drops when the ignition is switched.
the 8 volts doesnt seem right to me so tomorrow im going to see what im getting at every point it connects with something else. before and after.
can someone tell me where i can find the starter enable relay? i thought id check it out since i guess people say its a easy test and cheap. if not ill just wire up a push start button meanwhile i can get it fixed.
also getting a new solenoid tomorrow since mine the terminal got stripped a little and id want it to be good again.
did a battery load test and the voltage drops when the ignition is switched.
the 8 volts doesnt seem right to me so tomorrow im going to see what im getting at every point it connects with something else. before and after.
can someone tell me where i can find the starter enable relay? i thought id check it out since i guess people say its a easy test and cheap. if not ill just wire up a push start button meanwhile i can get it fixed.
also getting a new solenoid tomorrow since mine the terminal got stripped a little and id want it to be good again.
#3
Supreme Member
iTrader: (13)
Join Date: Apr 2005
Location: Not in Kansas anymore
Posts: 7,733
Likes: 0
Received 11 Likes
on
11 Posts
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: need starter help
8V where?
On the purple wire from the Ign to the solenoid?
#4 in pic at bottom of the page
https://www.thirdgen.org/vats_passkey_system
On the purple wire from the Ign to the solenoid?
#4 in pic at bottom of the page
https://www.thirdgen.org/vats_passkey_system
#4
Member
Thread Starter
Join Date: Nov 2010
Location: Sylmar, So-Cal
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 firebird bone stock for now
Engine: 2.8L V6
Transmission: 700R4
Axle/Gears: B.W 9Bolt 3.27 Posi
Re: need starter help
yea im getting 8v on the solenoid purple wire spot.
so i shouldnt need a new relay if it does send a signal right? ill try sanding down the terminals and seeing if thast helps
so i shouldnt need a new relay if it does send a signal right? ill try sanding down the terminals and seeing if thast helps
Thread
Thread Starter
Forum
Replies
Last Post
Gunner242
Electronics
7
12-25-2015 04:49 PM