AC harness Wiring Help
07-21-2013, 05:01 PM
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: May 2013
Location: Lake Havasu City, Az
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 camaro iroc z
Engine: 355 LT1 Full Roller
Transmission: T56
Axle/Gears: 9 bolt 3.73 posi
AC harness Wiring Help
Newb here with a not so newb question. I have an 86 iroc, and the previous owner removed the ac system, evap, blower, condenser, compressor, and even chopped the harness at the firewall. I have acquired everything I need to get started on fixing it all to put ac back in the car. I have a few questions on the harness.
what do these go to?
also, when putting the fan on high, it shuts off, Is this a bad switch or something else wrong?
I'm pretty sure my car was a factory carb car, and my next question is how many vacuum lines should be coming out of the firewall with the harness, The new harness has 2 smaller ones, where as the old one that is chopped only has one bigger one. I hooked up the bigger one to the carb and everything seems to work ok inside the car. Thanks for any help guys...
what do these go to?
also, when putting the fan on high, it shuts off, Is this a bad switch or something else wrong?
I'm pretty sure my car was a factory carb car, and my next question is how many vacuum lines should be coming out of the firewall with the harness, The new harness has 2 smaller ones, where as the old one that is chopped only has one bigger one. I hooked up the bigger one to the carb and everything seems to work ok inside the car. Thanks for any help guys...
Last edited by havacamaro; 07-21-2013 at 08:01 PM.
07-21-2013, 06:47 PM
#2
Junior Member
Thread Starter
iTrader: (1)
Join Date: May 2013
Location: Lake Havasu City, Az
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 camaro iroc z
Engine: 355 LT1 Full Roller
Transmission: T56
Axle/Gears: 9 bolt 3.73 posi
Re: AC harness Wiring Help
.
Last edited by havacamaro; 07-21-2013 at 08:02 PM.
Thread
Thread Starter
Forum
Replies
Last Post