Wiper motor AGAIN
06-10-2014, 05:29 PM
#1
Member
Thread Starter
Join Date: Jun 2012
Location: Texas
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82' Z28 Crossfire
Engine: 305
Transmission: Turbo 350
Axle/Gears: 3.42
Wiper motor AGAIN
So I replaced my wiper motor 2 months ago, and then the delay was not working yesterday. Half way to work, the wipers just locked up and stuck straight up. So I claimed warranty on the motor and it's working again, but they will not park. They move up and down like a twitch when in the off position. What is the problem? Is it the switch??
Delay works good but the regular LO- and HI- do not work so well
Delay works good but the regular LO- and HI- do not work so well
Last edited by TheIgnitious; 06-10-2014 at 05:37 PM.
06-25-2014, 05:44 PM
#2
Supreme Member
Join Date: Jan 2006
Location: Mooresville NC
Posts: 3,341
Likes: 0
Received 10 Likes
on
10 Posts
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
No Parking Zone
As to the parking problem, remove the motor cover, directly connect the motor, put the wiper stalk in the LO position, and see if the latch arm spring out and catches the drive pawl.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing !
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
When you see fog or “running” lights on in good weather beware. WLow performance driver ahead.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing !
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
When you see fog or “running” lights on in good weather beware. WLow performance driver ahead.
06-25-2014, 05:55 PM
#3
Member
Thread Starter
Join Date: Jun 2012
Location: Texas
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82' Z28 Crossfire
Engine: 305
Transmission: Turbo 350
Axle/Gears: 3.42
Re: Wiper motor AGAIN
As in makes the popping noise yes. I Made a latest post under help, if you could check it out.. To add onto that post, I figured out green,black, and grey wires allow the motor to park.... But I don't know how to allow this to help me
Thread
Thread Starter
Forum
Replies
Last Post