4th gen steering column
06-03-2015, 10:50 PM
#1
Senior Member
Thread Starter
iTrader: (3)
Join Date: Jan 2012
Location: Clark NJ
Posts: 877
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1988 Pontiac Transam GTA Notchback
Engine: 2003 Chevy 5.3 Vortec (325 cu)
Transmission: 4L60E
Axle/Gears: 3.27
4th gen steering column
Hey all, figured I would enlighten everyone who is not aware about this, just because when I was looking for an answer to compatability with steering columns - I found very little.
I purchased a column from a pick a part yard - from an 02 Camaro/Firebird
When It first arrived I noticed it was a tad longer than the 3rd gen column.
For now I will just say that the 4th gen column is a direct fit for 3rd gens. No modification necessary.
Also - those with radio controls stock on GTA's - if your cancel cam goes bad - or your horn starts going off when you turn the wheel - you might have to consider this swap to retain radio controls.
That is all for now.
I purchased a column from a pick a part yard - from an 02 Camaro/Firebird
When It first arrived I noticed it was a tad longer than the 3rd gen column.
For now I will just say that the 4th gen column is a direct fit for 3rd gens. No modification necessary.
Also - those with radio controls stock on GTA's - if your cancel cam goes bad - or your horn starts going off when you turn the wheel - you might have to consider this swap to retain radio controls.
That is all for now.
Thread
Thread Starter
Forum
Replies
Last Post
evilstuie
Exhaust
24
02-28-2016 03:33 PM