B&M Megashifter - Reverse Lights won't work
#1
B&M Megashifter - Reverse Lights won't work
I'm pretty sure it's wired up correctly. I even went through and redid the wires that were questionably hooked up back when I sucked at electrical. Hopefully y'all can see the picture. The fuse is not broken, I already checked. The reverse lights wont kick on in any gear. The gear selector indicator is damn near perfectly aligned, if that's relevant info. The reverse light bulbs are not broken. It is grounded to one of the nuts on the shifter assembly, as shown in the picture. If anybody can help me narrow down why my reverse lights won't activate, I have a fine reward available.
Also, the (B&M) relay didnt click at all through each of the gear selections nor when I turned the key to the on position.
Last edited by Wickydooda; 02-23-2020 at 09:53 PM.
#2
Supreme Member
iTrader: (1)
Join Date: Feb 2017
Location: Meriden, CT 06450
Posts: 4,034
Received 517 Likes
on
431 Posts
Car: 84 TA orig. 305 LG4 "H" E4ME
Engine: 334 SBC - stroked 305 M4ME Q-Jet
Transmission: upgraded 700R4 3200 stall
Axle/Gears: 10bolt 4.10 Posi w Lakewood TA Bars
Re: B&M Megashifter - Reverse Lights won't work
I don't know if this is happening to anyone else, but I can only see the very top of your picture.
#4
Supreme Member
iTrader: (1)
Join Date: Feb 2017
Location: Meriden, CT 06450
Posts: 4,034
Received 517 Likes
on
431 Posts
Car: 84 TA orig. 305 LG4 "H" E4ME
Engine: 334 SBC - stroked 305 M4ME Q-Jet
Transmission: upgraded 700R4 3200 stall
Axle/Gears: 10bolt 4.10 Posi w Lakewood TA Bars
Re: B&M Megashifter - Reverse Lights won't work
I can see it now.
#5
Supreme Member
iTrader: (1)
Join Date: Feb 2017
Location: Meriden, CT 06450
Posts: 4,034
Received 517 Likes
on
431 Posts
Car: 84 TA orig. 305 LG4 "H" E4ME
Engine: 334 SBC - stroked 305 M4ME Q-Jet
Transmission: upgraded 700R4 3200 stall
Axle/Gears: 10bolt 4.10 Posi w Lakewood TA Bars
Re: B&M Megashifter - Reverse Lights won't work
The only thing I can see from your picture is that orange wire with the black stripe looks like it goes to the steering column area where all those wires are cut.
It appears that it is cut also. Hard to tell though.
It appears that it is cut also. Hard to tell though.
The following users liked this post:
Wickydooda (02-25-2020)
Thread
Thread Starter
Forum
Replies
Last Post
chevycamaro91
Engine Swap
12
09-16-2007 12:29 PM