streetworkxs

I installed these headers on my tpi motor which was going in a g-body regal and turns out these don't fit. They headers were originally powder coated, I recoated them again with high temp header paint to try to bring down heat even more. I didn't tighten the headers down all the way, so the gaskets are still good (felpro 1404). Also included is a brand new header bolt kit. (zinc plated with special tool). I will let all of this go for $210 Shipped to lower states. Will post pictures tomorrow. I am in San DIego, ca 92129. These are smog legal no Y pipe included. These have been sand blasted inside out, ceramic coating was not removed. then high temp paint was put on. So these are the same as you would by them new. These have air injection

joeblue83

iTrader: (8)

That seams like a little much, I have a pair of tes that I am selling with the high temp paint for only 75. No dent and work perfect. Just trying to help you out

streetworkxs

how bout you get your own thread. I'm including everything you need for these headers. I put alot of time in cleaning up these things. They are in better shape than any used crap out there.

89junkyardgta

Hey, any chance you can list which part number they are? There's at least 3 different sets of TES headers for 3rd gens.

streetworkxs

edelbrock 68752

streetworkxs

$190 Shipped. These were on a '91 LB9 305 TPI. These will fit many other motors. Heres a picture

joeblue83

iTrader: (8)

Didn't mean to offend you. Mine look just like that without the tubes and no hardware. And I was not trying to sell mine, they were sold over a month ago. Just trying to help out a fellow third gener

streetworkxs

sorry for my response I didn't mean to jump out like that. I did lower my price and I believe the price is right now. thanks.