edelbrock performer rpm hydraulic roller cam
#1
Junior Member
Thread Starter
iTrader: (2)
Join Date: Sep 2007
Location: kiln, ms
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91rs
Engine: 6.0
Transmission: 4l60e/3600 vig stall
Axle/Gears: 3.73 9 bolt
edelbrock performer rpm hydraulic roller cam
i have a performer rpm hydraulic roller cam for a sbc oem roller block. this was exactly what i wanted, but as it works out i need a small base circle cam for the stroker its going in to.
i received the cam from summit tuesday, paid $229.95. installed it in my engine on the stand last night. was GENTLY turning over by hand to check for interference, and the #1 rod barely touches a cam lobe.
i dont know which lobe it actually touched, there are no marks or witness marks, but it did touch.
i can't return to summit because it has been installed.
$150 shipped to lower 48 for a 3 day old cam that has less than 1 complete revolution on it!
http://store.summitracing.com/partde...4&autoview=sku
i received the cam from summit tuesday, paid $229.95. installed it in my engine on the stand last night. was GENTLY turning over by hand to check for interference, and the #1 rod barely touches a cam lobe.
i dont know which lobe it actually touched, there are no marks or witness marks, but it did touch.
i can't return to summit because it has been installed.
$150 shipped to lower 48 for a 3 day old cam that has less than 1 complete revolution on it!
http://store.summitracing.com/partde...4&autoview=sku
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
09-17-2020 08:26 AM
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM