Putting in a new motor...
04-26-2006, 04:00 PM
#1
Member
Thread Starter
Join Date: Mar 2006
Location: 843/910
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Iroc Z
Engine: 350TPI
Transmission: 700r4
Putting in a new motor...
Is there anything i need to know about pulling the 350TPI and 700r4 and sliding in a turbo 350 and carb'd 400 small block? Any problems with room...also if anyone has a manual or a site to help me though this, itd be greatly appreciated.
04-27-2006, 10:49 AM
#2
Supreme Member
iTrader: (17)
Join Date: Jan 2005
Location: Mobile, AL
Posts: 2,716
Likes: 0
Received 2 Likes
on
2 Posts
Car: GTA
Engine: 383 HSR
Transmission: TH-700R4
Axle/Gears: 3.42
Read the sticky's on the top of the engine swap forum and use search. and a 400 will fit just as good as a 350 and the tranny will fit fine, but if I am not mistaken you will need a different driveshaft. There is much material on this.
04-30-2006, 01:38 PM
#3
Member
Join Date: Nov 2005
Location: Mlwaukee, WI
Posts: 243
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 camaro rs
Engine: 305
Transmission: 700r4
also will need to get a bracket assembly i believe band m makes it to bolt the torque arm to the differnt tranny
thanks
thanks
Thread
Thread Starter
Forum
Replies
Last Post