350 engine block, buy??
#1
Junior Member
Thread Starter
Join Date: Aug 2007
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 camaro
Engine: 3.1 v6, CAI
Transmission: t5
Axle/Gears: eaton posi
350 engine block, buy??
ok, i was looking on craigslist for a block to start on my 383 and found this for 50 bucks.http://minneapolis.craigslist.org/pts/528837321.html
its bored .60 over. will that be enough for a 383 or is that as much as it can be done safely? so, basically would this be a good buy to start up on?
-----------------------------------
found another one and thought i'd just post on this so i dont have to start a new one.
http://minneapolis.craigslist.org/pts/512084834.html
its bored .60 over. will that be enough for a 383 or is that as much as it can be done safely? so, basically would this be a good buy to start up on?
-----------------------------------
found another one and thought i'd just post on this so i dont have to start a new one.
http://minneapolis.craigslist.org/pts/512084834.html
Last edited by ossseo28; 01-22-2008 at 06:37 PM.
#2
Moderator
iTrader: (14)
Join Date: Mar 2000
Location: Littleton, CO USA
Posts: 43,169
Likes: 0
Received 35 Likes
on
34 Posts
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
For the sake of technical correctness, it's 0.060" over. I'll let "60 over" go, but not ".60 over".
Anyway, I'd pass on that one. Looks like it's been decked as well. Since it's been sleeved, it's had a pretty major problem already. .060" over is what's typically considered the max safe overbore, so if there's anything wrong with any of the cylinder walls you're looking at another sleeve job, or a paper weight. Even if the cylinder walls are straight, it would be wise to have the cylinders sonic checked for wall thickness - '76 wasn't exactly one of the "golden years" for GM production.
Anyway, I'd pass on that one. Looks like it's been decked as well. Since it's been sleeved, it's had a pretty major problem already. .060" over is what's typically considered the max safe overbore, so if there's anything wrong with any of the cylinder walls you're looking at another sleeve job, or a paper weight. Even if the cylinder walls are straight, it would be wise to have the cylinders sonic checked for wall thickness - '76 wasn't exactly one of the "golden years" for GM production.
#3
Junior Member
Thread Starter
Join Date: Aug 2007
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 camaro
Engine: 3.1 v6, CAI
Transmission: t5
Axle/Gears: eaton posi
Re: 350 engine block, buy??
alright thx.
"I'll let .60 over go"
hahaha i thought that was really funny
thanks again
"I'll let .60 over go"
hahaha i thought that was really funny
thanks again
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM