Engine swap
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Apr 2008
Location: Kansas City MO
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Car: 02 T/A
Engine: LS1
Transmission: Built 4L60E
Axle/Gears: 3.42 Posi
Engine swap
I am swaping from a 2.8 MPFI to a L98 TPI. I have a painless wiring harness for the engine and the correct ecm. Do I need to run any wires from the drivers side to the ecm? I pulled the motor and tranny, saw all the wires that run across the fire wall (after I separated a lot of them between engine harness and other) I am just confused at the amount of wires still going from the drivers side to the ecm. PLEASE HELP ME!!!!
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM