Lock nuts needed for headers?
10-12-2000, 07:38 PM
#1
Junior Member
Thread Starter
Join Date: Apr 2000
Location: Seattle, Wa
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
Lock nuts needed for headers?
Will be installing SLP headers in the next couple weeks was wondering if I need the Stage 8 locking header bolts? Have been told headers will loosen up and leak. Will regular lock washers work? I only want to do it once.
Thanks
1990 Formula 350
Thanks
1990 Formula 350
10-13-2000, 03:30 PM
#2
Supreme Member
Join Date: Aug 1999
Location: Woodland Hills, CA USA
Posts: 2,842
Likes: 0
Received 0 Likes
on
0 Posts
Car: Yes...
Engine: Last time I checked...
Transmission: See "Engine"...
Yes, header bolts like to losen up and create exhaust leaks. The Stage 8 bolts are the best way to go. Lock washer could work btu the trouble is you'll never be able to get them on. The clearance between the bolts and header tubes is too tight.
The best thing to do after you install your headers (with the Stage 8 bolts) is drive around for a few days, then re-tighten all the bolts. At that point I'd install the locking clips.
The best thing to do after you install your headers (with the Stage 8 bolts) is drive around for a few days, then re-tighten all the bolts. At that point I'd install the locking clips.
Thread
Thread Starter
Forum
Replies
Last Post
Zachattack0925
Tech / General Engine
2
08-12-2015 09:54 PM
Zachattack0925
Transmissions and Drivetrain
4
08-12-2015 09:52 PM
