Visors
09-25-2010, 06:17 PM
#1
Junior Member
Thread Starter
Join Date: Aug 1999
Location: Concord, CA, USA
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Z28, 1984 Z28, 1990 Toyota 4x4
Engine: L98, L69, 22RE
Transmission: 700R4, 700R4, 5Speed Manual
Axle/Gears: 3.73, 3.23 Posi, 4.10
Visors
After searching a couple of different ways, I couldn't find any info so here's my question:
Will 4th gen visors fit in a 3rd gen? Is it the same screw pattern for the mounts?
thanks
Zed
Will 4th gen visors fit in a 3rd gen? Is it the same screw pattern for the mounts?
thanks
Zed
09-26-2010, 11:57 AM
#2
Supreme Member
Join Date: Sep 2002
Location: Cary, North Carolina
Posts: 9,192
Likes: 0
Received 16 Likes
on
16 Posts
Car: 1992 RS
Engine: Carbed 350
Transmission: 700R4
Axle/Gears: 3.42 posi
Re: Visors
Stay away from the 4th gen visors - they are terrible! They are thinner cardboard than the 3rd gen jobs, and at this age they all look like trash and look much worse than any 3rd gen visor. The ends are designed to bend because of the rounded 4th gen interior, but the bend is simply a cut in the cardboard, so at this age theya re all just hanging on literally by a thread (of the fabric covering).
Trust me, they are junk - get a decent set of 3rd gen visors, recover them in your choice of fabric. I'm replacing my 1997 Z28 visors with 3rd gen visors because of this.
Trust me, they are junk - get a decent set of 3rd gen visors, recover them in your choice of fabric. I'm replacing my 1997 Z28 visors with 3rd gen visors because of this.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
