Seatbelt Guide
#1
Junior Member
Thread Starter
Join Date: Jun 2015
Location: Iowa
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro RS under construction
Engine: Building 500 rwhp ls1
Transmission: 4L85E
Axle/Gears: Moser Ford 9" 3.70
Seatbelt Guide
Okay so the seatbelt guide on my passenger side front seat is missing, and im looking at one, but the is nowhere to insert the seatbelt. on the guide that is on my drivers seat there is a slot for it where i circled on the pic, where do i put the seatbelt in on this one?
#2
Supreme Member
iTrader: (1)
Join Date: Aug 2008
Location: Short Summer, VT
Posts: 1,485
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1985 Trans Am T-Top
Engine: 305 TPI
Transmission: T-5 5 Speed
Axle/Gears: 3.42 posi 1LE 10 bolt
Re: Seatbelt Guide
I think that might be a fourth gen type, no cut out since they don't have lower retractors.
#3
Member
iTrader: (1)
Join Date: Jul 2015
Location: Schaumburg, IL
Posts: 223
Likes: 0
Received 3 Likes
on
3 Posts
Car: 1992 Polo Green RS Z03
Engine: L03 - 5.0 Liter V8 TBI
Transmission: MD8 – 4 SPD Auto
Axle/Gears: GU2 - 2:73 Ratio
Re: Seatbelt Guide
Original brackets were installed while the seat belt was being assembled, thus no slot.
I have not been brave enough to disassemble a seat belt to figure out how to install one correctly.
I have not been brave enough to disassemble a seat belt to figure out how to install one correctly.
#4
Senior Member
iTrader: (1)
Join Date: Jun 2014
Location: Southeast VA
Posts: 538
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Camaro RS T-Top
Engine: 5.0 Tbi
Transmission: 700r4
Axle/Gears: 3.42
Re: Seatbelt Guide
To add one back cut a slot between the screw holes, slide on belt and bolt back to seat.
Thread
Thread Starter
Forum
Replies
Last Post
xbazzarex
Interior Parts for Sale
8
12-01-2015 05:25 PM